Tip:
Highlight text to annotate it
X
Hi, I'm Terry Combs with Equipment Zone. Let's talk a little about pretreating shirts.
I'm often asked, "How can I get a better print with my direct-to-garment printer?"
And the answer is always in the pretreating.
By using an automatic pre-treat machine I'm gonna get consistency from shirt to shirt to shirt.
An automatic pretreat machine takes the variable out of the process.
The SpeedTreater-TX is the latest offering from Equipment Zone.
This professionally built machine is all-steel, all-electric
and doesn't require an air compressor to make it operate.
You know, pretreating shirts doesn't have to be rocket science.
it should be as simple as loading the shirt, pushing the button and
pretreating the shirt. That's what you get with the SpeedTreater-TX.
Let's pretreat a shirt.
Here's what to do. Open the drawer and load the shirt with the collar away from you.
Tuck it in and close the drawer.
Press the green button — those are all the instructions, press the green button —
In six seconds we'll have a completed, pre-treated shirt.
at the sound of the tone, open the drawer and pull out the shirt.
Off to the heat press and then to our direct-to-garment printer.
The most important feature of the SpeedTreater-TX
is that it can operate right next to my direct to garment machine.
When I close the drawer, it's fully enclosed. That means all the pre-treat stays inside.
I don't have to go into another room to pre-treat my shirts.
The SpeedTreater-TX has only two controls.
Remember, this isn't rocket science. We want to keep it simple.
The first control is a speed control.
By adjusting the speed control up and down I adjust how much pretreat goes on the shirt.
The second control is the length control. By adjusting these knobs
I control where on the shirt the pretreat goes.
So there you have it. The SpeedTreater-TX from Equipment Zone. The best investment you can make to improve your direct-to-garment prints.
Call us today for more information.