Tip:
Highlight text to annotate it
X
Hello everyone and welcome to this presentation about my new bottle: Ginette, I hope you'll be fine together. mistaaake...
Hello everyone and welcome to this new video presentation of the Beretta 92FS. ***, I was wrong...
Hello everyone, welcome to this video review of the Mosin Nagant 1891/30 sniper version, which has a problem, so I'll reassemble it for you. For disassembly, it's the same thing but in reverse.
To proceed, we need a Philips Screwdriver. A second with a smaller head if you want. A normal screwdriver and stamps clamp.
We have this lovely Lego, we'll start with the bolt.
It was the gas chamber......... which is located in the bolt at this place. We need an Allen key to remove the front. Be careful not to remove the valve too often to avoid breaking the seal.
Here we have the spring, which is not the original one (this is my problem). I advise you not to touch the original one, I cut mine too much and it doesn't work anymore.
In this helmet, we have a small packet of parts (screws, springs, etc..) The objective is to use all of this part on the rifle.
We'll start with the bolt. Pay close attention to that part, which is plastic, as it is fragile (I've already broken one).
Attention to the little ring here, it must be held to be able to introduce the bolt properly into the body.
We'll take this piece with the spring and we will put it here. Normally, we must shift the spring with a screwdriver in order to introduce this piece, but my spring is shortened so I don't have this problem.
We will then look for the screws that fit. (Philips screws). I advise you to put thread lock to prevent the shock wave makes the unscrewing. We can verify that it works well.
If you do that, it must do "click", whereas if you press down the nozzle, it will shoot. Here I've no more gas, so it's normal.
Then, the outer barrel (there are already inside the inner barrel with block-hop). No difficulty to remove internal, simply unscrew and pry with a screwdriver to slide of the outer barrel.
Then we assembling dad into mom paying attention to Nozzle. It must be tricky.
These slings are ***.
After 3 hours, it's reassembled.
For the next step, we need the loading system and little parts. We will mount the wood on the mechanism.
We need to move the magazine in the hole of the wood (unless you disassemble the charging system, I didn't want to do it).
This magazine is secured with two small screws on the fragile plastic support. We passed through the "U" of the body, and take the two small screws that we have here.
Then we will replace the part that will be used to secure the magazine (on top of the "U").
To attach our mechanism with wood, first should fix this little spring on the last screw, and the whole mechanism is put in the wood. Being careful not to block the slings.
We will replace the screws => one on the back of the bolt and another under the gun.
Then we have this little part that comes to block the mechanism. This is where we need the clamp for stamps, unless to make her own personal screwdriver.
Then we will mount the upper hand guard and the tip of the bolt.
For that, there is a small spring and a tiny ball that should not be lost. Then we have a special screw with a small thread, we will put the bottom, and it blocks the end of the bolt.
In removal tool, you also have the bayonet.
I advise you to put thread lock on the screw tip.
And finally, we will place the support of the scope. Attention, there is an order to put the small screws. It starts with the slotted screws, washers as well. They must be well positioned to form a full circle for adding the other screws.
And finally, we will mount the scope in its place, then we will tighten the screws.
The rifle was finally reassembled, if you have any questions, don't hesitate and I tell you "Dazvitania"