Tip:
Highlight text to annotate it
X
Now I will demonstrate this jig metal 70 which melt at a 70 degree
a metal is stuck below 70 degrees
This situation is dissolved, and this is the original metal
The dissolved metal is poured into the cup, cool in the water
Then it instantaneously solidifies, will have metal products
You can use it again many times
This is a process of aluminum, grinding down 27 mm to 30 mm plate thickness.
This standing walls are 0.3 millimeters
Usually grinding down like this thickness, it would have torn the walls
When you pour the metal, it can grind next space
If you stuff the metal to the pipe, you can bend the pipe without squashed.
At last you put pipe on the hot water to remove the metal.
This is a 0.2 mm stainless steel pipe, bored holes in the drill.
Without the metal, hole will be deformed, and with it don't.
There's no burr on the inside yet
It can be applied many in this manner.
finally,
When 0.2 mm thick pipe fastened with NC lathes, the pipe crushed in a hydraulic chuck.
A operator have been cut back or filling them with resin to prevent that.
With this product, stand the parts, pour the metal and cool it then it can grab with the hydraulic chuck
I think there is enough merit with it