Tip:
Highlight text to annotate it
X
With our rhodium tank plating kit all you have to do is set up our equipment and our
rhodium plating solution will quickly deposit a super bright layer of pure rhodium in minutes.
We've streamlined the process so all the plating settings are programmed in to the equipment
before you start plating so all you have to do is clean and plate your item. Once you've
set up your equipment, turn on your plating rectifier and make sure the output switch
is off. Adjust the volts to within a range of 3-3.4 Attach the red lead to the plating
arm which will......Turn on the output switch and adjust the current to the required level,
in this case 0.09 Turn off the output switch, reattach red lead to the mesh and adjust the
voltage on the small rectifier for the cleaner to 4.5
Preparing the surface for plating is very straightforward, just dip your work in our
cleaner for about 30 seconds and pass it through 2 rinse baths of ordinary water and you're
ready to rhodium plate. No need for dangerous acid baths, activation or extra layers of
nickel. Once your work is in the rhodium solution turn on the output switch and plate for three
minutes. Finish with a rins in the 2 water baths. And of course with our solutions, you
can plate straight onto sterling silver or yellow gold without having to pre-plate any
other layer. For a step-by-step guide on working out plating times and setting up our rhodium
kit, please see our tank plating section at the back of our manual.