Tip:
Highlight text to annotate it
X
Hi, this is Taylor. Today we're going to discuss how to refill an HP 88 cartridge. The HP 88
cartridges are all refilled in the same manor. It doesn't matter if they're extra larges,
black or any of the colors. To start refilling, simply cut along this top line here on both
sides, cutting the, just the a sticker, and the cap simply pops off. Once you've removed
the top, you can see the pump, the pump, the nozzle and then the fill area. To get into
the fill area, you need to remove the rubber ball in this area. Do not use it, you will
need to use it later. Once you have removed the ball, put it on the side. The next step
in refilling the 88, is to inflate the inside bag. To do this, just get a syringe without
a needle, stick in the side, and inject the air. Next step is to actually inject the cartridge
with the ink. To fill the, the ink bladder, only insert the needle, just a, about an inch.
Do not press too hard or you can pop the bag. Slowly inject the ink, filling the reservoir.
It should take about twenty milliliters. Once you've filled the 88 with the ink, replace
the rubber ball, press down firmly until you feel it click into place. Next thing, you
need to make sure is that there is no air. If there is air, simply insert the needle
and draw out the air. You can push the pump to create the pressure necessary for printing.