Tip:
Highlight text to annotate it
X
E Pipe Mod from GD
Welcome to the video about an unusual mod, E-Pipe mod.
When you hear e-pipe you think this should have something in common with pipes – and it has a bit.
E-Pipe mod is really a simple thing and we will have a look at it.
First some measuring:
weight 85,3 g,
diameter of a battery base 23,5 mm,
length including the switch 54 mm,
diameter of the part with 510 thread 16,54 mm.
So, the mod uses the standard 510 thread
and is designed for use with 18350 batteries, which you put in here.
I would like to point out the fact
that in case you don´t use flat batteries you must put the minus pole always down.
If you don´t do it this way and you put the little battery cap first,
you will just ensure a never ending switch of the mod.
As you can see, it shows me the voltage of the battery now,
never mind that the switch is off – and this is wrong!
So, the little cap of the battery always goes towards the cap…like this.
If you use flat batteries, then it does not matter which end goes where,
no danger here and the switch works allright.
You can see it shows the voltage only after I press the switch on.
So, be careful what type of batteries you are using.
I can show you the switch a bit more... It is also very simple.
It is just pressing directly on the battery… And that´s all.
Something is wrong...
I was misleading you… It happens too…
So, first the switch must go inside the plastic ring and only then on the mod.
Sorry for my mistake.
Let´s put the battery inside… And it´s ready to be tried.
So, we have disassembled the e-pipe, there´s not much to disassemble though.
The standard C4 fits great on this e-pipe mod, however I will use ProTank2…
And I will check it out.
It´s pleasant to hold, really… You can pick your way of handling it…
The switch is nice too.
So, this is E-Pipe mod.
Interesting thing, small, interesting design.
Have a nice time and see you at some of my future videos again.
For Gold Drive made by Vorel Vaping Film´s.