Tip:
Highlight text to annotate it
X
A Trenz Electronic Device is listed by "Cypress USB Control Center".
USB port is connected and EEPROM is switched ON: this two settings never change during this video.
Initial state: reset switch is in "run (work)" position.
Move the Reset switch to "reset" position.
Reset state: while the reset switch is in "reset" position, the USB FX2 microcontroller is in Reset state.
Move the Reset switch to "run (work)" position.
Run (work) state: the firmware has been moved from EEPROM to RAM.
Check VID (0DB0) and PID (0300) to verify that the module has been detected as a Trenz Electronic USB FX2 device.