Tip:
Highlight text to annotate it
X
Installing and adjusting
MP Rotators with Lawnbelt.
The MP rotator is offered in 2 different radius ranges, The MP 1000 8-15 the MP 2000 covering
13021 and the M_ 3000 covering 22 to 30 feet.
Each model is a avail with 3 arc adjustment options 90 to 210 degrees --- 210 to 270 degrees
and a dedicated 360 degree full circle.
Lawnbelt is an excellent match for the MP rotator and is very easy to install. For the
purpose of this video we are showing the U fitting above ground. Normally it will sit
in a 10" deep hole with Lawnbelt attaching to both side.
To begin make sure you wrap all connections 3 or 4 times with teflon tape.Tehnt attach
the Rainbird Sprinkler Body to the 1/2" thread at the U Fitting. Twist in on till is snug
tight, do not over tighten.
For the purpose of this video we are showing the U fitting above ground. Normally it will
sit in a 10" deep hole with Lawnbelt attaching ato both side.
Next pull on on orange plug and remove it. Then insert the MP rotator into the top of
the popup and screw all
the way on.
Additionally attach the Lawnbelt to each side by sliding it on all the way and lastly slide
the clamp with colar halves so that it offsets about 1/8" of an inch away from the end,
Once Lawnbelt is in the ground you can tighten the clamps using a 5/16" ratchet wrench in
order to seal the system.
To adjust the angle or arc adjustment point the indicator to the left side of the watering
area. Just twist the popup as shown - you;ll hear a ratchet noise but this is perfectly
ok.
Next turn on the water -- - and turn clockwise to increase the angle of the spray and watering
area -- up to a maximum arc for the MP rotator being used.
Adjust the radius with the by turning the screw on the top of the nozzle - the radius
can be reduced by 25% on all MP rotator models
Turn the screw clockwise to decrease radios or counter clockwise to increase radios -- four
full turns will take you from a minimum to maxim radius
Visit us today at: www.lawnbeltusa.com
help@lawnbeltusa.com