Tip:
Highlight text to annotate it
X
Prior to tagging, we had placed two circles
corresponding to the thickness of the adipose tissue, we measured ultrasonically periumbilical area
with the patient standing we perform the measurement of the area to be treated,
through a low marking corresponding to the supra *** area immediately,
and laterally reaches the depression that occurs in the abdomen produced by the oblique,
and passes horizontally just above the umbilical region, taking the total adipose tissue,
after this marking, which we grate, we will establish comparisons
after applying the Biomolecular Vibration system or focused ultrasound
and then take the ultrasound of these two areas.
In practice, we began the session by applying a pre-cooled gel,
is a gel that has a certain consistency to avoid having temperature increases the skin,
and then we started the session, the movements are slow,
in areas previously marked, always remember that the marks we make up,
ultrasound measurement prior and after treatement with tape measure
to see the result of Biomolecular focused ultrasound system.
We begin with the marking on the abdomen,
first epigastric area where we see a significant deposit of adiposity,
mark the top area, and in this case also, we have redundancy of fatty tissue in the lower abdomen, which also marked,
and in these cases we could also mark the area corresponding to the flanks if we want,
and on the other hand exactly the same, mark the areas of the flanks,
that's about the mark,
the next step is to take an ultrasound of fatty deposit to establish its thickness
and then immediately proceed to the application of the HIFU that is focused ultrasound is those areas.
Since the mechanism of the focused ultrasound system produces a high temperature,
the first step is to cool the area, for it in the treatment areas use a gel with medium consistency,
this is to avoid the sensation of heat in the patient,
by the increase in temperature that will produce the ultrasound system,
once you've covered the areas to be treated, also cover the head with a gel of the same characteristics,
and immediately going to program the device, usually in these cases we programmed in the program "Lipolysis",
and we will do it for 20 minutes in the upper abdomen and the lower
Here we begin, turn on the device, we will immediately warn,
if the camera appreciate it, the movement that makes the gel
it looks as if the gel were boiling
and started with the application, the application is smooth, upward motion (Does it burn? - no)
and we do it in various positions, ascending,
attempting to achieve a significant rise in temperature is checked by touching,
First we make a emi belly, if we find it more easy,
usually when we are close to the rib cage, there may be a rebound wave, and the patient may express some displeasure with the treatment,
but in areas of greatest fat no such sensitivity,
always is very important, when we are making this application, there is an abundant amount of gel,
to prevent the temperature rise, note that with this system the inner temperature is increased,
not on the skin, is in the inside, that's why we talk about lipolytic effect.
The temperature rise is due to the effect of cavitation having focused ultrasound system,
that cavitation is going to increase significantly the temperature,
show later, do a demonstration on pig fat
and you will see the effect of cavitation and the temperature rise