Tip:
Highlight text to annotate it
X
Changing tracks a little too "rubber".
I need a miter saw.
An alu flat bar 20x2mm aluminum. (Possibly 25x2mm)
And a plan.
I start by putting a saw kerf for grooves
then cut at 45 °
40 will be needed for each track. :-(
I use the track origins as support. I remove the edges to stick to my piece of aluminum.
To simplify my life, I glue by strips. I use a ruler to ensure that all parts are aligned.
I use cardboard strips as spacers.
I place a new piece ...
and I scotch. And so on.
Finally, I fixed together by a thicker tape. Surplus on the right, will keep all on track.
I positioned on the track ...
I unroll, I put the glue, I put it back and I tighten. (watch out for fingers)
etc...
And one over.
And a second.