Tip:
Highlight text to annotate it
X
In this clip, we're going to be working on taking off the back tail end of the bike,
so we can go ahead and get to that exhaust. We're going to start first by taking our Allen
Wrench bolts off. That's going to be right here. Go ahead and use your five millimeter
Allen Wrench and you're going to take off all four bolts. There's going to be one in
each corner. This is going to be the first one right here. Taking that one off and then
go ahead and continue by taking all four off. For the last two, the ones back here, should
all be the same size. Then like I said before, make sure you put away all your bolts in a
nice safe place. Try to remember the order that you've taken them off so when you reassemble
your bike, you can make sure you put them back together in the right spot. Some bolts
are going to be longer than the others. The ones in the front were shorter. These ones
are longer. We're going to separate these to make sure we put them back in the correct
spot in the rear section. Go ahead and take off your last bolt. Next, we're going to be
taking off these plastic clips right here. I'm just going to use a regular Phillips Screwdriver
and unscrew them. Don't go too hard because they are plastic and can strip them. You just
want to go real gently. You're just going to unscrew them like so and pop them right
out. Go ahead and unscrew these, they'll become loose. I've got my finger underneath it, so
I'm going to be pushing it up as it comes out. Then once you got, you can twist it with
your hand a little bit. Then it'll pop right out. Mine, it came apart but that's fine,
you can just go ahead and pull it right out then. There I go, just like that. That plastic
part, it looks like that, it'll pop right out. Make sure you keep those together and
don't lose the pieces. Then go ahead and do the other side when you're done.