Tip:
Highlight text to annotate it
X
In this clip we're going to we're going to cut two pieces of 1 by lumber with a taper
cut. I made a very shallow taper cut on this one. But for this clip, I'm going to make
a much deeper taper. Our adjustment screw is set at half inch right now. I'm going to
change it to one inch. I gone a little too far, so I'm going back in. Ok, so that should
be just about an inch.
Set the piece up against the adjustment screw, make sure your blade touches right where you
want the taper to begin. Tighten down your rip fence and let's make the cut.