Tip:
Highlight text to annotate it
X
The factory ABC control unit is located in the passenger side floor board
Pull the carpet back to reveal the kick panel
Using a 10mm socket remove the 3 plastic nuts
Now pull the kick panel forward to reveal the ABC control unit
By removing the 8mm bolts that secure the ABC control unit to the panel you will have some extra space to work with
Now remove the large and small slide connectors from the ABC control unit
Next take the QuickConnect harness and insert the connector into the ABC control unit. Take the other end and connect to the the factory harness. Do this for both the large and small connectors
Now attach the ABC control unit back to the board.
Attach the M1 module to the D-sub connector
Now take the twisted pair CAN wire and run it to the drivers side.
Next remove the torx screws that attach the under panel and pull it down to get access to the CAN block
Run the wire under the panel and connect it to a vacant slot on the CAN block
Reassemble the panel
Hid the wire and make sure the ash tray works without binding.
Use the Velcro strips to attach the M1 module to the board
Now reassemble the floor panel
Now you are ready to make adjustments to your suspension
Start the vehicle.
Put the car in Drive (some work in Park) Press the phone end button for 5 seconds
Press the phone end button again to access the front ride height
Use the - and + buttons to lower or raise the front ride height
Press the phone pick up to save the setting
Press the phone end to access the rear ride height. Choose the value and use the phone pick up button to accept
Now you will turn the module on and off using the phone pick up button. Press the phone end button to exit