Tip:
Highlight text to annotate it
X
So now I'm going to show you the lid for the other cell tea pot. On this one the important
measurement is going to be the inner area, because it's the stem whose diameter is going
to be most important. So I'm going to hold these calipers right above the center line.
And I want them to be set so that they're just at the inner line there, so now that
I've got my calipers set I'll put them to the side and I will start centering the lid.
So for this one, I'm going to start out with a little bit of a lens shape, but then I'm
going to go ahead and again, push down a little ***, and I'll check this with my calipers
before I go any further, now I can see my inner cylinder isn't nearly wide enough, so
I'm going to go ahead and pull this whole thing out a little bit more. Check it again.
That's a lot better, so now I can go ahead and pull up the inner ***.