Tip:
Highlight text to annotate it
X
this is chamfer vertex
now with chamfer vertex we need to be in polygon state
and you go to edit mash down here is camper vertex but first we have to select
a vertex to chamfer
and basically what this means is that this was like
in shop class where we plane off an edge or a corner
so a chamfer vertex will split this open and create a face
based on how many edges lead into it, so we have four edges in here
so this will be a four-sided face
so we go to edit mesh
chamfer vertex
and under these settings we have um... width control
how big or small it'll be
and reset the settings here
and hit chamfer vertex and you can see here we've made a four sided face made a four-sided face
based on the edges leading into it
and going to the top we have one two three four eight
edges leading into the middle here to this vertex
I go in to chamfer vertex
you can see now we have
an eight sided
face... an n-gon
again if i want to control the
size of the chamfer
I can either make it smaller
or larger with the width control
or if I want to remove the face and make a hole
I can click on remove the face after chamfer
that'll create a hole in your geometry
that is chamfer vertex