Tip:
Highlight text to annotate it
X
Today on our 2013 Chevrolet Equinox well be test fitting the Kuat Sherpa fix mounted two
bike rack with wheel mount cradles, part number S102. To begin our test fit using the included
adapter for the two inch hitch well slide our bike rack shank into the hitch, line up
the hitch pin hole and install our hitch pin. Well then move to the back of the shank where
well tighten the *** down, securing our bike rack to the vehicle. With our bike rack secured
well now go ahead and give you a few measurements. Our ground clearance at the bike rack is 12
inches and from the closest point of the bike rack to the back of the vehicle is two inches.
Well now unfold the bike rack platform and open our cargo door.
As you can see, we can still gain access to the cargo area with this bike rack secured
to the vehicle. Were now almost ready to load our bike. Well need only to make sure that
our front wheel clamp is fully extended and that our rear wheel strap is undone and out
of the way. Well place the bike into the mounts and bring our front wheel clamp up, clamping
the front wheel just in front of our front brake caliper. Well then move to the rear
wheel strap where well put the strap through the wheel and secure it on the other side.