Tip:
Highlight text to annotate it
X
hey what's up guys welcome to Dirt N' Iron today I'm going to show you how to
load a dirt bike into your pickup truck an easy way! so stick around !
a couple of things we're gonna need today ramp some kind of step straps and a lot of momentum
before you do anything you need to prepare your straps my bed is short
only five point five feet so I cannot fit my bike straight I need to put it like
this that's why my strap would be one over here and one in the front
there is one little trick if you can park your truck a little bit downhill
so my straps are ready ramp is here and this is my step
I like to use this stand because you can use it as a step when you're loading your bike
give yourself 10 to 15 feet in order to get momentum get some speed and
push it up it's very important where you put your step it should be in the
correct position so it's easy for you to step up it's not a bad idea to try it
once without the bike make sure everything is very supposed to be and
then just grab your bike and push it up
once your bike is in get first strap that is in the back of your truck strap it on
your handlebars and let your bike lean a little bit this side
make sure you don't pinch any cables or wires
there you go a little bit a little bit like this
do the same at the other side this strap is in the front of the truck
again watch for cables and wires and what not
once you have that just tie it up a little bit
I like to make my bike straight always come on the other side and pull
it down make it straight
all right that's about it bike is going nowhere
it's not that hard just remember to have a little bit of momentum
put your, start with your bike maybe ten feet apart from a truck and push it
up hill get a little bit speed a little bit momentum put it up here have your
straps ready and you're good to go
all right guys that's about it for this video
hopefully you enjoyed it and don't forget whatever you do stay MOTOvated
see you guys later