Tip:
Highlight text to annotate it
X
In this step, we will cut the front panel away from the back panel and then cut the
back panel the exact same way we did the front panel. To cut the front panel off, we drew
our line six inches from, six inches from the top, down. We will line that line up with
the outside of the blade and cut the panel. We now set our miter to fifty-five degrees.
We line the blade up with our mark that we made three and a quarter inches from the side,
down, and we will line that mark up with the inside of the blade.
We now move the miter to the other side of the table, of the blade, put the bottom of
the board against the miter. Line our point up with the outside of the blade and cut that.
We now must cut the board to length. We set our miter back to ninety degrees. We line the six inch mark we made from the
end of our board to the outside of our blade and we cut the board.
That is how we cut the front and back of our bird house.