Tip:
Highlight text to annotate it
X
Vertical Blinds are easy to install, in this short video you will learn to install them.
A screwdriver is all that’s needed to install your blinds; or for an easier installation
you can use a cordless screwdriver or a drill with a ¼” Hex head bit. Before starting,
carefully unpack your blinds and mounting hardware. To familiarize yourself with the
contents of your box, check the printed instructions included with your product. From the point
at the bottom of your window where you want your blind to hang, measure up to the top
of the window, the length of the blind that you ordered. Make a pencil mark at the top
of your measurement, and center your headrail on the mark. Make a mark, 4 inches in from
each end of the headrail. Align the top of your left bracket along the inside of your
pencil line and fasten to the wall with the supplied screws. Rotate the clip at the end
of the mounting bracket to make it easier to install your screws. Repeat on the right
side and for any additional brackets. Hook the front of your headrail into the bracket
and rotate back until it snaps into place. The portion of the vertical blind that rotates
is called the vane, to make it easy to install the vanes, begin by spacing the vane stems
evenly by pulling the cord. Pull the chain to rotate the openings in the stems, so that
they face you. Attach the first vane by gently sliding it up into the plastic stem until
it snaps into place. Repeat until all vanes are attached. Install the safety bracket to
keep your cord fairly taught. Install the bracket near the outside bottom of your window
frame, where it will not interfere with the operation of your blind. Your blind may come
with a decorative cover called a valance. A valance is used to cover the top mechanism
of the blind, and can be installed easily too. If your valance comes with inserts for
each section, slide the inserts into the edges along the front of each one. Insert the valance
ends into the corners and attach to the front. Attach the included valance clips onto the
headrail and slide the valance onto the clips. Finish by testing your new blinds. Carefully
pull down on the cord to slowly open your blinds, and then pull the cord again to completely
close them. Pull the beaded chain to rotate your blinds. And that’s it, if you still
have any questions about the installation of your blinds just give us a call, it’s
that easy.