Tip:
Highlight text to annotate it
X
OSMOCONTROLLER digital Electronic refill system with digital probe
INSTALLATION
Place the electronic controller in a dry place, NOT within the aquarium cabinet
Fill the SUMP to the desired level
Attach the included bracket to the side of the SUMP and attach the sensor to the bracket using the 2 included zip ties. The level sensor should be submersed between1-3 mm below the water level
Connect the sensor via the USB connection to the controller and carefully route all cables to avoid electric shock hazards
Place the pump inside the RO tank making sure that the exit of the water hose is positioned well outside the water and above the maximum height of the RO tank to avoid, “back siphoning” of the SUMP into the RO tank
Connect the power supply to the Main Supply. After 5 minutes the instrument is ready for operation
Note: Generally in the SUMP, it is suggested to place the sensor approximately a minimum of 2-4 cm above the return pumps/skimmer
After 5 minutes, the controller will be ready to keep the correct level and, if necessary, will replenish the water through small additions(approximately 500 milliliters) every 15 minutes
SIGNALS RED LED: LEVEL ALARM - No RO water - The pump may be damaged or clogged - The tube may be blocked
SIGNALS GREEN LED: CORRECT OPERATION flashing quickly: at starting and for the next 5 minutes light on: the level is correct Flashing slowly: the level is low, the controller performs the necessary top-ups (every 15 min.)
SIGNALS YELLOW LED: PUMP OPERATION light on: the pump is running
HOW TO USE THE PUMP Simply pressing the “M” button will activate the pump. This function is very useful for making small additions, mixing additives with RO water or filling an extra container of RO water. DO NOT USE THE PUMP WITH LIQUIDOTHER THAN RO WATER.