Tip:
Highlight text to annotate it
X
bjbj G2^\ So we have a standard RC, RX-18 module and receiver from Heng Long, that works
at 27 MHz. We have TX crystal 40.685 MHz (taken from Futaba), we put into HL RC. We switch
on RC, the model itself. As you can see HL receiver has the same freq crystal RX 40.685
Antenna has to be taken out, to make the signal better. So here we go! This was 68th channel
- 40.685. To avoid any replies that this could be just an exception, we decide to experiment
with three crystals 40th MHz: we take 51th channel 40.675 MHz. Let s see what we will
have here. Transmitter and receiver The same procedure, we switch it here and here As we
see the model is alive So we have another crystal 40.850 MHz. Let s try it next. Again
Transmitter, receiver We switch it on and here we go The model works and is alive. So as the conclusion HL RC works
not only using 27 MHz, but 40MHz as it has been shown and proved So we have a standard
RC, RX-18 module and receiver from Heng Long, that works at 27 MHz KATE Normal KATE Microsoft
Office Word So we have a standard RC, RX-18 module and receiver from Heng Long, that works
at 27 MHz Microsoft Office Word MSWordDoc Word.Document.8