Tip:
Highlight text to annotate it
X
Assembly instructions for Wavy Hoop 2B.
There are a total of 8 sections.
Locate the section that has a button, it will later connect with the section that has a hole.
Note: There is only 1 section with a button and 3 section with a hole. Set aside section with hole. This will be connected last.
Start with section that has button. Insert the stem of any section (and save one with a hole last) into the hollow end.
*Important: The flat grooved part on the stem on the section must slide along the bump inside the hollow end of other section. Once inserted, twist.
Continue connecting the remaining sections. Pay special attention to matching the bump inside the section to the grooved line of the stem part.
Make sure you twist enough to feel the sections lock into place. If the sections of the hoop do not line up evenly then continue to twist the sections until they do.
Careful not to over-twist. If the sections lay flat on a table surface then they are correctly attached.
Finally, the last two sections will be the ones with the hole and button.
Hold down the button[before entering it into the hollow end of opposite section] Pull both sections together until you hear a click sound.
Adjust sections so button enters hole and the sections lock into place. Gently tug to make sure hoop is assembled.
Your hoop is now assembled and ready for use