Tip:
Highlight text to annotate it
X
repair a clinic encourages you to perform this procedure safely
in this video we will show one or more of these icons
to alert you when to use caution
as with any repair be sure you've unplugged the appliance before beginning
your first step is to pull out the lint screen
and removed the two screws near the opening
next insert a putty knife under the front of the main top to release the two
spring clips
and rotate the top up
disconnect the door switch wires
and remove the top front panel screws
now lift the panel up and out
if your model has two front panels
use a flat head screw driver to release the lower panel from the retaining clips
if applicable remove the two springs
now loosen the two screws at the bottom of the upper panel
and lift the panel off
if still intact remove the old dryer belt by depressing the pulley to release
the tension and unthreading the belt from the pulley and motor shaft
install the new dryer belt by placing it rib side down along the outside of
the drum
insert the tension pulley into the slots in the base and loop the belt around the
pulley and motor shaft in a zig-zag formation
rotate the drum to help align the belt
if your model has a solid front panel line up the drum with the front panel
seal
than align the slots with the retaining clips and press down the panel until it
locks into place
if your model has two panels align the slots in the upper panel with the screws
while lining up the drum
tightened the screws
if applicable reinstall the two springs
and replace the lower panel by snapping it into position
now reinstall the two screws on top
and reconnect the door switch wires
rotate the main top back into place and pressed down on the front to secure the
spring clips
installed the two screws at the lint screen opening
replace the lint screen
and plug the appliance back in to make sure it's functioning properly