Tip:
Highlight text to annotate it
X
Today on our 2002 Ford Van well be installing the ETBC7 brake controller seven and four
way installation kit part #: #TBC7. First well start at the back of the vehicle. Well
mount the bracket for our sever four way plug. To mount the bracket well go ahead and set
the bracket up where wed like to mount it and then using a paint marker well mark the
holes thatll need to be drilled out. Because of the thickness of the bumper well use a
small drill bit as a pilot hole and then step up to our larger size. Now with our holes
drilled out well go ahead and take a couple of self-tapping screws and secure the bracket
to the bumper. Now we can go ahead and take the seven and
four way plug and using the hardware provided with our install kit secure it to the bracket.
Next well take the four way plug and connect it to the four way plug coming out of the
new seven to four way wiring. Now with our two four poles connected well go ahead and
cut off the purple wire which is used for reverse lights on a trailer, but not on this
application. Well go ahead and take the gray duplex cable provided with our install kit,
strip back a couple of inches, strip it back and connect it to the black and blue wires
coming out of the seven to four way plug. The black wire, well connect it color for
color to the black wire from the duplex cable using the yellow but connector already attached
to our
seven
to four
way plug.