Tip:
Highlight text to annotate it
X
Assembly instructions for Acu Hoop 3lbs large and Acu Hoop 4 lbs large
There are a total of 8 sections.
Locate the blue section with the button; this will be the first section you begin with.
Notice that it has a button and will later be used to lock into the last section which will be the purple section
Please note the purple section has a hole which connects to the button of the blue section.
Set aside the purple section, it will be the last connector.
Insert the stem of a non-purple section into the hollow end of the blue section.
*Important: The flat grooved part on the stem of the section must slide along the bump inside the hollow end of the blue section.
Once you slide the section into the blue end, twist.
Make sure you twist enough to feel the sections lock into place. If the sections of the hoop do not line up evenly then continue to twist the sections until they do.
Continue connecting the remaining sections . Pay special attention to matching the bump inside the section to the grooved line of the stem part.
Careful not to over-twist. If the sections lay flat on a table surface then they are correctly attached.
Finally, the last two sections will be the blue and purple sections.
Hold down the button on the blue section before entering it into the hollow end of the purple section.
Continue to pull both sections together until you hear a click sound. Adjust sections so button enters hole and the sections lock into place.
If you are unsure if the button is locked, you can gently tug on the sections.
You can also gently roll back the foam on the purple section to make sure the button is correctly locked.
Your hoop is now assembled and ready for use