Tip:
Highlight text to annotate it
X
Today on a tall dodge caliber were going to install the drag tight hitch number 24769
here are a couple of measurements that will assist you in selecting accessories for your
new job such as a hitch such as a bike rack or a cargo carrier and the center of the hitch
pin well to the outermost part of the bumper is 7 inches, from top of the receiver tube
to the ground is 13inches, now lets go ahead with the installation.The installation process
is take our 4inch 5of the bolts and go ahead and feed them into the frame from the outside
to the inside, now the bolt will go on all the way through the frame however you want
to keep it flushed with the frame until we get our hitch in place, well do this for both
sides.We need to process the do here on the drivers side well repeat it identically on
the passenger side, now the hardware in place, well go ahead and push the bolts through the
frame into the hitch.Now the hardware in place well go ahead and push the bolts through the
frame into the hitch up and push the bolts through the frame into the hitch, now with
the bolt holding the hitch in place well take our 5A lock- washer about 5A nut then, thread
them on to the end of the bolt Ill go and repeat the same process for all the attachment
points.Now with all our fasteners in place, well go and tight them down, now with all
our fasteners tightened down, were going to talk to stressifications as indicated instructions
and with all our fasteners charged to specifications, that will complete the install of our tro
dodge draw tight hitch, part number 24769 on our 2011 Dodge Caliber.