Tip:
Highlight text to annotate it
X
Alright, today on a 2011 Chrysler 200 we're going to do a test fit of part number N102
from Kuat. One thing you need to know about this bicycle rack, it is designed for 1-1/4-inch
receiver hitches only both class I and class II. Well start off our test fit by installing
the bike rack into the hitch. We'll install the hitch pin and lock on the other side.
And then well go ahead and pull back on it and push some tension on the pin and then
tighten down the anti-rattle device. Alright now, well go ahead and get some clearance
measurements. Alright from the bike rack to the bumper as
closest point will be 4-1/2 inches, ground clearance will be 8-3/4 inches, and thats
with the anti-rattle *** set horizontal. Lets go ahead and unfold the bike rack and
well go ahead and show access to the trunk. Now, we can go ahead and load up the bike.
First thing well do is well raise up the clamp and extend it all the way and out of the way
and then well go ahead and loosen the strap for the back wheel. When we load up our bike
well put the front wheel into the cradle and then well bring the clamp down on top of the
tire as close as we can to the front brake.