Tip:
Highlight text to annotate it
X
The XP system has a ethernet interface module called XP 130, and it is the module responsible for driving the data wires, on the communication bus.
With data to and from the PC where you have contool running.
So on the XP 130 you have and ethernet connection to you local area network
you have a standard configuration of the low voltages screw terminals, with a plus and minus
24 volt you have D and E, which can be used together with plus and minus, the D and E makes the 4 wired bus to the conson push button series.
Besides that it has 8 ordinary input which can be used just like the old CP 20.
It also have an RS for a 5 connection 4 wire up here and it has a couple of analogue input.
and a couple of NTC termister input for measuring temperature.
On the front of the module you see some indications for bus activity and ethernet connectivity.
We try again. On the front of the module you will have 2 light indications for bus activity.
That means the conbus and for ethernet activity.
Besides that we have a push button, which is a security push button, so that you are not able to change setup in the modules, on less you have pressed this push button first.
It's a feature that can be enabled or disabled within the module, but it's there for safety.