Tip:
Highlight text to annotate it
X
How to Drill into Your Wall. Drilling into your wall while knowing where the studs are
and not hitting any wires may seem daunting, but it's simple if you follow these steps.
You will need Drill bits Pencil Hammer Countersink Drill Anchor Hook or screw Stud finder with
a live wire detector (optional) and heavy-duty tape (optional). Step 1. Select the right
drill bit for the job. If you're drilling into sheetrock or plasterboard, you can use
a drywall bit; use a masonry bit for brick, block, stone, quarry tiles, or concrete; use
a spur point bit to drill through wood; and use a tile bit for ceramic tile or glass.
Step 2. Avoid drilling above or below light switches or electrical outlets. If you have
a light switch or outlet on the second floor, don't drill below it on the first floor -- the
wiring likely goes down and through the first floor. You can use a stud finder with a live
wire detector as a secondary measure. Step 3. Be careful drilling into a bathroom wall
-- or into any walls that are shared with a bathroom. You risk hitting and damaging
your pipes; this also applies to areas around radiators. Step 4. Use a pencil to mark the
place on your wall where you want to drill and, using a hammer and countersink, make
an indentation where the hole will be. If you're drilling into ceramic or glass, make
an X with heavy-duty tape over the surface before you drill. This will prevent cracks
and chips. Step 5. Place the tip of your drill bit into the indentation and gently squeeze
the drill's trigger, making sure to keep the bit straight. Step 6. Slowly increase the
bit speed as you apply pressure. When you've achieved your desired depth, slow the bit
down, but don't stop it. Keep pressing the trigger and slowly pull the bit from the hole.
Step 7. Insert an anchor into the hole if you need to, and then screw in your hook or
screw. You are now ready to hang decorations on your walls! Did you know In 2009, drywall
imported from China that was used to build American homes was found to contain contaminants
that can form corrosive sulfuric acid.