Tip:
Highlight text to annotate it
X
Installation of the SINVERT PVM photovoltaic inverter must be carried out by qualified
expert personnel only.
This video serves as a supplement to the operating instructions.
The minimum clearances from walls, ceilings and adjacent devices must be observed in order
to ensure reliable operation of the convection-cooled inverter.
The wall bracket also serves as a drilling template for marking of the drill holes.
Make sure that the arrow markings on the wall brackets point towards the top.
The inverter's mounting should always be carried out by two people.
Hook the inverters cooling ducts into the wall bracket's top lugs
and attach them to the insert nuts at the bottom.
Use the screws included in the accessory kit to fasten the device to the wall bracket.
Please observe the VDE guidelines for electrical installation.
First, ground the device via the marked ground stud
and then connect it to the power supply system by means of the enclosed connector.
Then connect the PV strings to the inverter.
Depending on the model 4 or 6 connections are possible.
You can now put the system into operation.
Use caution when choosing the country identifier.
After one-time selection during initial set up the country identifier can only be changed
by a Siemens customer service technician.
However, the menu language can be re-adjusted as needed.
Communication is realized via Ethernet or RS 485.
Following free registration the SINVERT web monitor facilitates global access to all current
system data.