Tip:
Highlight text to annotate it
X
Before you start, please prepare a screwdriver.
Remove the 4 screws connecting the cover to the camera head.
Unplug the LED module power cable from the sensor.
Remove the LED module from the cover
and unplug the power cable.
Remove the 4 screws connecting the lens to the camera head.
Unplug the lens power cable from the sensor
and remove the lens.
Remove the 6 screws located at the bottom of the base.
Remove the base's top cover
and unplug the 2 power cables connecting the cover
to the keyboard and microphone.
Remove the 4 screws connecting the arm to the base
and unplug the power cable.
Remove the 5 screws connecting the keyboard to the base.
Unplug the remaining power cable.
Push in the 2 connectors holding the enter button in place
and remove the button.
Remove the 4 screws connecting the mainboard to the base
and remove the mainboard.
Before we start,
please prepare a toolboard, SD card and a PC or laptop.
Start by formatting the SD card.
Copy 7 files to the SD card.
Power on the visualizer
and check the firmware before upgrading.
After confirming the firmware version,
insert the SD card into the visualizer.
Insert the toolboard and power cord.
Press the power button until the power light begins to flash.
After approximately 30 seconds,
the playback light will flash blue.
Remove the power cord to complete the upgrade process.
Now power on the visualizer
and confirm the firmware was upgraded.