Tip:
Highlight text to annotate it
X
Hi! This is Mike on behalf of expertvillage.com. For more information about bicycle maintenance
please visit Prairie Path Cycles in Winfield, Illinois or visit our website at www.prairiepathcycles.com.
In this clip I’m going to be showing you how to tighten your brakes. Now the first
sign you’ll notice that you need to tighten your brakes is it when you pull your brake
lever it goes almost all the way to your grip which it shouldn’t do. You should be only
pulling it about a quarter or half way to the grip if you are brakes are adjusted correctly.
Now the first method you are going to want to use to try to tighten your brakes is up
by your brake lever. There is a barrel adjuster that when you turn left or counterclockwise
pulls out, which tightens up the cable and brings your brake arms closer to your wheel,
which will tighten it up and there is a little locking nut on the barrel adjuster that snugs
tight to your brake lever and once you get that done you can check your brakes and you
can see they are still pulling a little bit too much so if you do need a bigger adjustment
than what your barrel adjuster can do there is a nuts on the rear brake arm, which when
you loosen up hold down the cable and push the brake arms closer to the rim. Once you
get it close enough to the rim but still not touching tighten that bolt back up and then
check with your brake lever again to see where it is at and you can see now it doesn’t
pull nearly as much as how it was before but if you decide that still it is a little bit
too tight or little bit too loose you can use your barrel adjuster to fine tune it to
get it exactly how you want to pull and that is how you tighten your brakes.