Tip:
Highlight text to annotate it
X
We are going to go ahead and install part number 18002. Which is the Draw Tight 4 pole
flat onto this 1998 GMC Jimmy. Right now we are underneath the vehicle. We have already
put the hitch on here. As far as the wiring goes about 90 percent of the Chevy Blazers
and GMC Jimmys have the tow package on them. It is that bundle of wires that attached to
the backside of the bumper with zip tie. Those are all the wires we are going to need to
attach the 4 pole too. So what we are going to do is go ahead and clip the zip tie here.
Then release these wires and as you can see they give you a substantial amount of lead.
Again the 4 pole flat connector we will be using is made by Draw Tight and is part number
18002.
In the the packaging as of the 18002 they provide 4 quick splices for you to use along
with a 60 inch harness. I am going to go ahead and peel back the tape here at the end of
the tow package. You need to cut back about 6 to 8 inches to fully access all the wires
in here. As you can see here we got a light green, yellow, dark green, light blue, and
a brown. Then taped off to the side is a white wire which will be our ground. Now that we
have all the wires pulled out of the tow package. You can see that they will coincide with the
other wires on the 4 pole harness that we are installing. Yellow to yellow, dark green
to dark green, brown to brown, and
white
to white.