Tip:
Highlight text to annotate it
X
Today on our 2012 Cadillac SRX we're going to install the Draw-Tite Hitch, part number
75682. This is what our hitch will look like once it's installed. We'll go ahead and give
you a couple of measurements to assist you with selecting accessories. From the center
of the hitch pin hole to outer most edge of the bumper is 3 inches, from the top of the
receiver tube to the ground is 19 inches. This will assist you with selecting accessories
such as a draw bar, a bike rack, or a cargo carrier. Now let's go ahead with the installation.
Our first step is to remove the rear fascia door. There are two fasteners securing it
in position. With the fascia door removed, we'll now have access to the two weld nuts
in the bumper support. Next we need to remove the spacer blocks, one on each side and secure
the rear fascia. There'll be two fasteners and one nut that will need to be removed in order
to remove one
of the spacers.