Tip:
Highlight text to annotate it
X
I-Hybrid V1 Raptor Compact from Gold Drive
Hi, welcome to the video about one of the pioneers of so called compacts,
or rather series production compacts I-Hybrid V1 Raptor Compact.
So let's take a look at it.
The set is packed in a leatherette case which we will open right away.
So, the set includes the I-Hybrid V1 Raptor Compact,
two 18350 batteries of 800 mAh,
travel charger, service set with a little screwdriver,
some resistance wire, two o-rings, and a small roll of mesh.
Let´s have a closer look at the Compact now.
Why compact?
Because this device is a rebuildable I-atty atomizer as well
as a body with a switch at the same time.
Everything makes one piece, so it is compact.
There is no thread for connection of these two parts as we are used to,
mostly EGO/510 these days.
So, there is no such thread here.
Material: aluminium, everything is really light,
parts of the atomizer are stainless steel, the tube is pyrex glass.
It's delivered with a ready-made heating system from the producer.
There is mesh
so before the first use it is good to check short-circuits which may occur.
Resistance of this heating system is 0,8 ohm
which is ok for mechanical mod.
This is on/off switch, controlled from the bottom,
so it works with the minus pole
and you should watch out for any damage of your battery insulation.
I am putting inside an 18350 battery,
screw it in, this is a safety lock,
if you unscrew this ring you can start heating.
Well, we have some short circuits here – hot spots…
Ok, now it heats all nicely.
So, we can just fill in some liquid and start vaping.
I will measure the Compact first.
Length without a drip tip 113,5 mm,
with a drip 135,2 mm,
diameter almost 21 mm.
Inside cap diameter 18,8 mm,
depth almost 17 mm.
As I already said, the base for heating is an I-atty atomizer.
I will not dissasemble the I-atty from this Compact
but I can show you another piece of I-atty here.
It is a Genesis system, totally simple,
mesh hole, screw to hold one side of the coil,
screw to hold other side of the coil, screw enabling to fill in you liquid.
To take I-atty to pieces you need to remove this upper screw,
is pleasantly big, then the threaded little tube,
unscrew the upper base and the pyrex glass tube is open.
Of course, you can move the center pin as well then.
You can also remove the pyrex glass part
and then you can remove this center as well.
Everywhere you can see silicon sealing, everything is well sealed.
I think that´s all we can say about I-atty disassembling.
Now, I have to put everything back step by step.
Ok, center sealing,
a little tube,
screw,
the air hole goes opposite the coil.
That´s I-atty.
We did not weigh the Compact yet, I will remove the battery,
because each of us may use a different one.
The whole Compact weighs 57,2 g, you can see it´s aluminium.
Fill in your liquid, let it soak up, and vape.
I filled in some 3 ml of liquid which is kind of a standard for I-atty,
flicked, and now I can vape.
Standard I-atty performance.
There´s really nothing to do wrong,
also with 0.8ohm it works very well,
we will see how it works some time later.
So, ok, everything´s checked,
have a nice time and see you soon at some of my videos again.
For Gold Drive made by Vorel Vaping Film´s.