Tip:
Highlight text to annotate it
X
We need: One 3cm wide book One 2cm wide book High temperature silicon
1 cutter Steel wool 2 empty beer/coke cans 1 full can (unopened)
Get the blade fromthe cutter and put it on top of the 3cm book
Spin the can several times in order to make a groove on the can
Stub the nife on the grove to make a clean cut
This will be the upper part of the stove
Take the nife and patiently cut the bottom of the other empty can
and use the 2cm book to cut the bottom of the can
This will be the upper part of the stove
For avoiding toxic smokes and a better seal..
Sandpaper the paint and the plastic with Steel Whool
..inside and outside..
Use the unopened can to strech the bottomer part.
Warning: Strech the BOTTOMER PART (the 3cm one)
Warning: May become damaged easily. Be careful!
Cut a rectangle using the left over can.
And again, sandpaper the paint in both sides
Draw a 4cm X 18cm rectangle
And cut it with scisors
Before using silicon, we better check if both parts match
Ready! Silicon!
Cut off 3 little chips along one of the long sides..
And at 1cm from each extreme, make a 2cm cut. One side from top to center and the other from bottom to center for the to overlap and have a cilinder.
Cilinder works! Lets glue it with silicon now.
Also silicon the inner ring
Glue cilinder and top part together (the 3 little chips side goes on top, without silicon)
Just RIGHT NOW you can see those 3 little cuts.
Spread silicon along the inner walls of the bottomer part.
Close it!
Use a little piece of can as a helper for fitting one into the otherujar" hacia adentro..
Voila!
Just the little burning holes missing!
One way: Using a drill
Another way Using a thin pin.
Ready! Wait 24 hours before using it!
Pour >90º alcohol an lit it up carfully It will take 1 minute to be 100% power