Tip:
Highlight text to annotate it
X
So, now that we've prepped the board and we've mixed up our Q-Sail, we're going to go ahead
and apply it, and fill in that hole that we just prepped. So, what you do is you just
take your squeegee and just kind of really, try to get it way in there, and get it inside
there, fill in all those, you know, little holes and crevices that got pushed into the
foam by the fin. And, then once that's done, what I would do, is just grab a little bit
of extra and then just really kind of give it a nice float on top, because all this stuff,
this sands really good. So, after we, you know, apply it like that, when we come back
and get ready to fiberglass it, then we'll just be able to sand it right off and, it
sands really sweet. So, that's perfect, as long as what we want is it to be above where
the damage was. Once that's dry, then we'll come back, we'll sand that down, and then
we'll go ahead and apply the fiberglass.