Tip:
Highlight text to annotate it
X
Hi I'm Karen for Expert Village I'm going to show you how to end our spiral knot bracelet
with an end knot. First lets cut off our extra thread that was holding that, we don't want
to cut up our loop, just our thread, and then we're going to take all the strands and tie
that figure 8 knot. So come around your finger across the front, around the back and back
through the hole and then you want to tie it as close to the end of the pieces as possible.
We'll do a little of wiggling to get that down there and pull it down nice, and tight,
figure 8 makes a good lumpy knot cause we need that to hold the bracelet on. Pull it
nice and tight and remember to leave about a quarter inch on the end, don't cut it right
up close becuase the could cause the knot to come undone, about a quarter inch __ discard
that and then you can open up your loop put your loop right up on there, the loop just
gets caught on the knot like that and that's our spiral bracelet.