Tip:
Highlight text to annotate it
X
So now, I'm going to go ahead and open this. I'm pushing with my left index finger. I'm
going to leave a little bit more than a quarter of an inch at the bottom here so that I'll
have some thickness where I can add a little *** on to this lid. Checking with my needle
tool to make sure that my thickness is good. Same process, right thumb underneath and then
I'm going to pinch this up. Now, the first thing I want to do is see how wide this needs
to be. So I need to get significantly wider in order that this won't fall right into the
bottle. So I'm going to take my hard rib and I'm going to push the base out towards it,
but not the top. This needs to be tapered so that it will fit nicely into that bottle.
So now my caliper is hit right about here, so the bubble will fit above the top of the
neck, which is what I want. I'm just going to stretch it out a little bit more.
And, if the top is a little bit uneven, you can take your needle tool and just cut it
right off and then even out that rim one more time. So now, we're going to let this dry
up for a little while and I'll show you how to put a little *** on top of it.