Tip:
Highlight text to annotate it
X
SPEAKER 1: The Performance Distributors LiveWires
are an excellent addition to the Hot Forge Distributor
and the Screamin' Demon coil, because they'll
get all that extra spark energy to the spark plug.
They feature a very low resistance,
about 300 to 350 ohms per foot.
They're spiral-wound so you don't end up
with any radio interference.
They have heat-shrinked ends to keep the moisture out
of the boots, a heat braid that is a good up
to about 1,400 degrees, and they're also cut to length
and numbered for each cylinder, making them the best plug
wire for your Mustang.
Replacing your spark plug wires is very simple
and doesn't require a whole lot of thought.
However, I do want to point out a couple of things
that you want to keep in mind-- namely, the firing
order and then how to remove the spark plug
wires from the spark plugs.
Now starting on the passenger side, at the front,
you have cylinder number one.
Then two, three, and at the back is number four.
Then moving over to the driver's side,
you've got cylinder number five at the front,
and six, seven, and number 8 is at the
very back next to the firewall.
Now on top of the cap, the firing order
is one, three, seven, two, six, five, four, and eight.
The coil is in the center.
Now to remove your spark plug wire,
it would be easier to give the boot a twist
and then pull it away.
Now these Performance Distributors LiveWires
fit great and didn't take long to install.
Now when changing out spark plug wires,
it's a great time to go ahead and change out
your spark plugs.
Now for more ignition components for your Mustang,
check out latemodelrestoration.com