Tip:
Highlight text to annotate it
X
Today in the 2005 dodge magnum were going to install curt hitch part no. 13465. This
smaller hitch will look like once it is installed to the vehicle now lets going to give you
a couple of measurements this will assist you as like this accessories such as the draw
bar a bike rack and a cargo carrier. From the center of a hitch pin hole to the outer
most edges in the bumper is 7 inches. From the top of the receiver tube to the ground
is 10 and a quarter inches now lets go ahead with the installation before we can begin
in installing our hitch we need to first lower the exhaust as the toll of four hangers that
has to be remove one in front and one behind both bumpers. To remove the hangers Im first
going to spray each rubber hanger a little spray lubricate note on the passenger side
there is also a ground strap that it have to be remove well set that aside for reinstallation
later. Now ready to go ahead to start removing our
hanger while prying the hangars up cant be done we also have a tool that can make it
easier there are two hangers from on the passenger side or to the same process on the driver
side. If you are looking for an additional working remove above the mufflers you can
also go ahead and remove two exhaust hangers just behind the first mufflers. And each side
we have total of three attachment points here on the driver sides starting from the rear
attachment point there is a well mutt the center attachment point is also well nut and
our forward attachment is going to be bolt and block. Well bit that to the access hole
here in the frame on the passenger side again starting from the rear attachment point is
a well nut and in the forward two attachment points will be bolt and block just like the
four attachment points. Lets go and get our well nuts clean out and then
well get our bolt
and blocks
in place.