Tip:
Highlight text to annotate it
X
In this clip, we're going to talk about the proper service procedure to retro fit your
vehicles air conditioning system from R-twelve to one thirty-four A. And, recharge the system.
In this step, we're going to talk about locating of the the low pressure service port and changing
of the fitting on your vehicles AC system. The low pressure service port on this particular
vehicle, is located right here. The way to identify where it's going to be at, is it
will be between the AC evaporator which is this component and the compressor. The compressor
is located right here. Now, just the kind of geographical location of where it is does
not matter. What you're going to want to follow is the line itself. This line comes out of
the evaporator, down into the receiver dryer and comes back out of the receiver dryer and
runs to the compressor. As you can see, that indicates this as my low side or suction side
service port. Unscrew the cap and discard it. This cap will no longer be used, it won't
fit on our new fitting. We're going to take and clean these threads up with some rubbing
alcohol. You're going to want to use a solvent of some kind. I prefer rubbing alcohol for
this kind of fitting. Because, it leaves no greasy residue at all. Just get a dab of it
on there, like so. And, wipe around the threads. If your threads are extremely corroded, you're
going to want to use a wire brush or possibly some sandpaper to get that corrosion out.
What our fitting has on it, is a permanent thread lock and sealant. If you look inside
the fitting, you can actually see there's some pink stuff inside there. That is your
thread lock and sealant. You're going to want to take your longest fitting and I have three
to choose from. You're going to want to take your longest fitting and screw that onto the
low side suction port.
It's going to feel a little gooey as you tighten it down, just due to that thread lock and
sealant that you're squeezing through.
Once, this fitting is installed and it sets and cures it is a permanent fitting. You do
not want to try and remove this again, due to the fact that gross damage to the receiver
dryer or the fitting will occur. That is the proper way to locate your low side fitting
and replace it with your retro fitting.