Tip:
Highlight text to annotate it
X
How to sew zip into trousers. Usako's sewing studio. http://yousai.net/z/
Making the facing and the extension.
Put the facing material on the reverse of the facing and extension fabric.
Adhere with an iron
Apply pressure, for about 15 seconds , on to the iron by pushing straight down.
Lift and place it to the next arer.
Don't slide the iron along the material.
put the paper pattern on to the material and mark around it. On youhave done this cut along the lines.
Noow,Sew around all the edges.
Fold the extension in half.
Noow,Sew along all the edges.
When you reach a corner, leave the needle in and turn the material.
Rock stitch around the edge of the facing
Apply stay tape to the front to the facing,
If you're using facing material you only need to cut a thin strip.
I'll stick to something like this
The fastener sticks to this section.
Sew the inseam before a zipper
When the (zip ends), snip the material as a mark.
sew between the (snip) and the (crotch).
Don't forget to backstitch at the start and finish.
Sew the facing before a extension material
the front of the body is inside side out
The facing upside down.
Fold the facing material under.
Sew the topstitching from the end of the opening.
Sew the edges together about 2-5mm in from the edge.
Can I put two stitches 2mm and 5mm
Seam allowance of the previous center hidden in this
Take the ziper.
Open the zipper and use it inside out.
Keep a small edge between the zipper and the edge of the fabric.
Sew the right-side end of the zipper.
Sew to the end of the opening.
Sew the extension material
I piled those who clamshell to be outside
Sew the extension material to the center front.
Sew inside the margin at 1 or 2mm.
Will overlap of the 1 ~ 2mm before this
Fold the seam allowance on the back and taking out the fastener causes
1 ~ 2mm stitch at the end
I will come to an end because the inside of the seam allowance sewn inside 1 ~ 2mm
I sew without having to worry about because this is sufficient overlap
layer the front 1 ~ 2mm and stop it with a pin
Fold the facingside front under.
Pin the facing and zipper only.
That should not be taken out stapling
Facing and sew the zipper only
I sew the ends of the fastener
Sew a stitch from face side
Attention, don't sew the extension material.
It's easy when I draw a line with a erasable Tailor's chalk
I will not be able to wear and sewn into the awning without taking out
1 ~ 2cm stops short of sewing end
Return the extension material at right position
Sew this part
How to sew zip into trousers. Usako's sewing studio. http://yousai.net/z/