Tip:
Highlight text to annotate it
X
Step 1: Remove the screw protruding from the bottom of the engraving system. This screw
holds the motor mount assembly securely in place during shipping. Insert the screw with
the washer into the rubber grommet located on the back of the engraving system.
Step 2: Mount the air filter. Loosen or remove the top screw.
Place the screw through the top hole on the air filter bracket.
Tighten the screw.
Step 3: Connect the air filter hose. Connect the supplied short, black hose to the straight
fitting on the filter. Connect the other end to the air input fitting on the back of the
engraving system.
Step 4: Connect the foot throttle. Please note: the foot throttle hose should not be
pinched or kinked. Insert the hose into the fitting marked "throttle connection".
Step 5: Connect one or more GRS handpieces. Use only a GRS Standard Handpiece or a GRS
Airtact Handpiece with a standalone Airtact control system. Connect the Standard Handpiece
hose to the handpiece push-to-connect fitting. Turn the handpiece selector *** to the handpiece
fitting being used.
Step 6: Connect the electrical power. Please note: use only the supplied 24-volt power
converter. Insert the converter cord into the receptacle on the engraving system. Connect
the electrical power cord into the 24-volt converter box. Use the supplied 2-prong power
adapter as needed in Europe.
Step 7: Connect an oil-free air supply. Do not operate without
an oil-free compressed air supply connected and powered on.