Tip:
Highlight text to annotate it
X
Today on our 2008 Nissan Frontier, we'll be installing the Draw-Tight Hitch, part number
75282. This is what our hitch will look like once it's installed. Next, we'll go ahead
and give you a couple of measurements to assist you with selecting accessories for your new
hitch. From the center of the hitch pinhole to the outermost edge of the bumper is 3-1/2
inches. From the top of the receiver tube to the ground is 15-1/2 inches. This will
assist you in selecting accessories such as a drawbar, a bike rack, or a cargo carrier.
Now, we'll go ahead with installation. Before we begin to install the hitch, we'll go ahead
and point out the attachment points. There are a total of six attachment points, three
on each side. These attachment points will be well-nuts built into the frame by the manufacturer.
Over time, these well-nuts can build up with rust, dust, dirt, and debris, so what we recommend
is spray each one with some spray lubricant, and clean it
out with a half-inch nylon tube brush, part number 814092.