Tip:
Highlight text to annotate it
X
We prepare the mate, ok
well, we need yerba (don't smoke it!)
sugar if you want drink a sweet mate and
water at 80 degrees and THE MATE (very important jaja)
so you need to fill the mate with 3/4 of yerba
ok?, 3/4 of the mate
if the yerba is increasing his volume you need to a little less
well,
theres is, can you see the yerba? great
so, now the idea is
make an inclination of the yerba in the mate, as you can see
and then we introduce a little of water in the hole
This sector of yerba must be dry
and here is wet by the water
ideally let the mate sit for a minute
to coat well the yerba with the water and obtain a good flavor
after introduce the tube (through which mate tea is drunk)
we cover the end of the tube
now, introduce in the mate
put through the hole where we put the water
so, do
the other end of the tube leads to the other corner of the mate
then remove your finger from the tube
introduce water into the mate on the tube (activity name: CEBAR)
the water should slide over the tube, not on the yerba
so the impact of the hot water
firt contacted the tube
finally we see that generates a foam (very good!)
that means we prepate a good mate
and we always part of the yerba must by dry
when the yerba loses its flavor (Status of mate : LAVADO)
take the end of the tube and coverring it and then turn it 180 degrees
we continue to puting water in the new side of mate
and that's all
this mate sucks!
turn it off