Tip:
Highlight text to annotate it
X
Now that's still a little bit too wide for a spout so I'm going to collar that up just
like this. I'm going to speed the wheel up. One of the things that I like with the teapot
spout is if it becomes uneven, I want that to happen. This one actually isn't as uneven
as I'd like it. Because when I have it uneven, when I have one side a little bit higher it
just makes a nicer angle on the actual teapot. When it's attached to the teapot I should
say. I am almost set except that I want to give this a surface that matches my teapot.
And the way I'm going to give it that surface is by using the same rib tool that I used
on my teapot. Now notice that's my pinky. That's how narrow I want this. I'm going to
just give it a little quick pull like that. And then I will just clean that up a little
bit. And then you're going to take it off with the wire tool. And this is what the bottom
will look like. That is all set to dry and then I'll cut it and attach it to the teapot.