Tip:
Highlight text to annotate it
X
Hello to every body im Theo for "Craft it easy"
today we will see how to create an object that you like
to suit most
for example, a helmet...a part of a suit
anything!
we will see it from the beginning till the end
let we see how to begin
well guys, the first thing that we do is to open pepakura!
i have show to another video how to download and install pepakura
Now. The first thing that we must do is to download the archive about the object that we want to create
for example i want to create iron man's gloves right now
the right thing is to download the full suit
my suit is...mark 6
we go for example...not here...
but here...
and we found it here.
press here to download it...
nice...we download it...
we open it
for example is this here
here is the fingers
the front side of palm
...the down side...
and up side
now. Because i have small hands
let's go to make it smaller
we go right here
i will write in it, 48
and press "ok"
we will put then all in one A4 paper
we go here at "file"
first we go "print and paper setings"
change this to A4
and this to "portrait"
press "ok"
again to "file"
..."print"
and..."ok"
well.These is that have it print us
you can see
let's go now to cut them
and after the cut...one by one
we place them on the foam
in this case, my foam is 3 mm thick
because is for the gloves
if you will create iron man's suit, better use 4mm and over
and take a pen
to sketch a perimeter on the foam
and after we will cut it with our papercut
and after we have cut them all
we'll stick them together with the hot glue
which halts each, we will see it on pepakura
at the 3d image
and like this we get the result that you will see later
well ok. After we have create our glove
the next thing is
is to pass it four layers
with this glue that i've shown you
let's go to see how we do it
here is the glue
let's put inside a little glue
as much water we have here as glue we'll put
we mix it...
we want a little bit more
very well.We mix it up!
to take this form
our glue with the water
we begin to baste the piece that we have made
firstly, will be look like this
but do not bother you
these all white spots will be gone
let's wait for a while to see it how will be
that's how it became
it has some spots on it
but it doesn't bother us
its time to layer it one more time, ie second time
and two more times later
ok guys, we've finished the sealing
we have basted four times with our glue the glove
as you can see it has start to shine...
is still flexible
it doesn't get any damage
i think is ready for painting
that's it guys
we've finished with your glove!
as you can see i can move my fingers
any notice you have...any questions, comments, negative...positive
write them down to the comments
or send email
till next time..bye
...and cheers!!!