Tip:
Highlight text to annotate it
X
Welcome to the video presentation of the concrete ultrasonic measuring instrument from
riese electronic GmbH of Horb am Neckar. The BEUS determined the exact time of solidification
of concrete. How easy is that I will show you.
Open the locking tabs and lift the cover
Sample from formwork.
Make sure you have a tight fit of the sample formwork
on the measurement plate.
layer of the concrete to be measured in the sample mold
Compacting the concrete carefully interleaved and
regularly by poking. This approach is essential
because air pockets in the concrete distort the measurement result.
Fill the sample formwork completely.
Then slide the concrete surface smooth.
Now open the lid of the control unit and switch
BEUS by pressing the On / Off - button.
If the BEUS "Ready" Indicating
can press the measurement of "measuring" button to start. From now on, the BEUS Works without supervision.
If the BEUS has recognized the solidification time, it switches
automatically. When you turn the BEUS again, the result is
the last measurement displayed automatically. In this case 10.8 hours.
By pressing the button "last measurement" the result can be queried again.
Now the BEUS can be cleaned. To remove the formwork is
the supplied wooden block.
Then clean the surface plate and the mold with a sponge.
Avoid scratching the surface plate.
This is the simple operation of BEUS. With a few easy steps, it gives
you the precise solidification time!