Tip:
Highlight text to annotate it
X
Today on our Ford Escape, we will be installing the Tow Ready T-One connector, part #118566.
First, were going to begin by opening up the rear cargo access door. Then, well will remove
the two fastener covers that attach to the tail light assembly on the drivers side. Once
we remove the covers, we can then remove the four fastening screws here on the drivers
side. Now, with the screws removed, we can go ahead and remove the drivers side tail
light assembly. To do this, well gently pull and pry out this tail light assembly until
it pops free. Be careful not to break the alignment tab
underneath when removing the tail light assembly. Next, to disconnect the tail light assembly
completely, well press on the locking tab for the wire connector and remove it from
its socket. Next, well need to connect the yellow and brown wire from our new Tow Ready
harness. To do this, it will be easier to feed the wire from up underneath the vehicle.
We will take our piece of air tubing or our pull wire and feed it down between the plastic
bumper cover and the body or sheet metal
of
the vehicle.